Advertisement
5.
If any
errors
occur during the process, the message block will display a red warning.
message instructions to resolve the
Note: In some case, errors are discovered after [Finish] stage, a fail-calibration report also be generated.
6.
After calibrating the test machine, you can refer to the [Installation Guide] to replace it with the next one and
click [Reset] or [Next]. Then, repeat steps 1 to 4 for a new round of calibration. Or refer to [Retrieve Report]
to get report.
* No need to restart UNOKIT power after replacing the next test device.
7.
After completing all calibrations and retrieving the reports following the next section, please remove the test
device, turn off the power, and store the power cord.
issue, then click [Reset] / [Next] or reboot UNOKIT.
Please follow the
9
Advertisement
