Daikin MC80ZBFVM3 Operational Manual page 21

MODE
Automatic airflow rate adjustment
FAN setting (Quiet, Low, Standard, High) is automatically adjusted according to the degree of air
impurity.
Purifying capacity increases as airflow rate rises.
AUTO FAN
If operating sound is a concern, airflow rate can be changed.
※
Maximum airflow rate during AUTO FAN MODE is High, which is lower than Turbo.
• Degree of air impurity corresponds to the volume of dust and the intensity of the odours in the
ambient air.
Saving energy
In power saving mode within ECONO MODE, the FAN setting automatically switches between
Quiet and Low only. Power consumption (※1) and operating sounds are minimised.
If the air is clean, after about 5 minutes, Monitoring mode automatically activates.
Recommended for use during sleep hours.
※
1 By comparison to AUTO FAN MODE (approx. 14.3Wh), power consumption in ECONO MODE
(approx. 7.4Wh) is approx. 6.9Wh lower.
Test condition case in Malaysia: Operation in 12.4m² room over 1 hour. Assuming 1 cigarette was
smoked immediately after the unit was turned on.
ECONO
FAN setting switches
automatically with an
airflow rate of Quiet or
• As the FAN setting is limited to Quiet and Low, air purifying capacity is reduced.
• Since the air in the room is not drawn in while the fan is stopped, the sensitivity of the PM2.5 sensor
and odour sensor will decrease. To prevent this reduction in sensitivity, turn Monitoring mode OFF.
Page 25, 26
Living with pets
A gentle air current is created by switching between the FAN setting between Standard and Low
PET
every 5 minutes to continuously remove pet's hair.
• The airflow cannot be manually controlled in this mode.
When you want to circulate the air in the room
The air in the room is kept clean and local variations in temperature are suppressed. It is even
more effective if the unit is installed opposite an air conditioner.
The airflow rate is High for about 30 minutes after operation start, in order to circulate the air in
the room.
CIRCULATOR
After that, temperature change around the unit is monitored and FAN setting is automatically
adjusted.
(There is no temperature adjustment function)
• If the indoor temperature is low, FAN setting may not be set to High.
(To reduce chills caused by airflow)
Usage and Function
Power saving
mode
If the air is clean,
Low.
If dust or odours are
after about 5 • The fan starts and stops
minutes... periodically. Dust and odours are
monitored.
• The following functions are turned
OFF to further reduce power
consumption.
Streamer
detected...
Active Plasma Ion
Operation
Page 25, 26
Monitoring
mode
OFF
OFF
20