Nikon ECLIPSE E400 Instructions Manual page 3

WARNING
ZE
Intended product use
XE
L
Do not disassemble
Disassembly may cause malfunction and/or electrical shock.
Do not disassemble any parts other than those mentioned in
this manual. If you notice any malfunction, notify your nearest
Nikon representative.
ο
Confirm the input voltage
Make sure that the input voltage indicated on the back panel
of the microscope is the same as your regional voltage.
If
not the same, do not use the microscope; instead, notify your
nearest Nikon representative.
If the microscope is used with
the wrong input voltage, a short circuit or fire may result,
causing the damage of the microscope.
Power cord
To prevent electrical shock, always turn off the power switch
(flip it to the ©" side) before connecting or disconnecting
the power cord. Use only the power cord provided with the
microscope. (Refer to p. 24.) Using the wrong power cord
could result in damage or fire.
$,
eat from the light source
The lamp becomes extremely hot.
To avoid burns, do not
touch the lamp and the area around it while the lamp is lit or
for about thirty minutes after the lamp has been turned off.
Furthermore, in order to avoid the risk of fire, do not place
fabric, paper or highly flammable materials (such as gasoline,
petroleum benzine, paint thinner or alcohol) near the lamp
while it is lit or for about thirty minutes after it has been
turned off.
The back of the microscope also becomes hot during use.
Although this is not a malfunction, be careful not to touch
the back of the microscope when it is hot.