Table of Contents
Advertisement
2019/10/25 23:34:43 (GMT+09:00)
• Note for Printed Wiring Boards and Schematic Diagrams
Note on Printed Wiring Board:
• X : parts extracted from the component side.
•
: parts extracted from the conductor side.
•
: Pattern from the side which enables seeing.
(The other layer's patterns are not indicated.)
Caution:
Pattern face side:
Parts on the pattern face side seen from
(Conductor Side)
the pattern face are indicated.
Parts face side:
Parts on the parts face side seen from
(Component Side)
the parts face are indicated.
Indication of transistor
C
Q
These are omitted.
B
E
D
Q
These are omitted.
G
S
Q
B
C E
These are omitted.
Q
B
C
E
These are omitted.
• Abbreviation
AR
: Argentina model
AUS
: Australian model
CND : Canadian model
E4
: African model
E12
: 220 – 240 V AC area in E model
EA
: Saudi Arabia model
LA9
: Latin-American model
MY
: Malaysia model
RU
: Russian model
TH
: Thai model
Note 1: When the complete MOTHERBOARD board
is replaced, refer to "NOTE OF REPLACING
MOTHERBOARD BOARD OR BLUETOOTH
MODULE OR RC-S730 (WW)" on page 7.
Note 2: When the MS-476 board is defective, exchange
the entire LOADING COMPLETE ASSY (T).
HCD-SHAKE10/SHAKE30/HCDSHAKEX10/HCDSHAKEX30/HCDSHAKEX70
Note on Schematic Diagram:
• All capacitors are in μF unless otherwise noted. (p: pF)
50 V or less are not indicated except for electrolytics
and tantalums.
• All resistors are in and
1
/
W or less unless otherwise
4
specifi ed.
• 2 : nonfl ammable resistor.
• C : panel designation.
Note: The components identifi ed by mark 0 or
dotted line with mark 0 are critical for safety.
Replace only with part number specifi ed.
Note: Les composants identifi és par une marque
0 sont critiques pour la sécurité.
Ne les remplacer que par une piéce portant
le numéro spécifi é.
• A : B+ Line.
• B : B– Line.
• Voltage and waveforms are dc with respect to ground
under no-signal (detuned) conditions.
no mark : TUNER
<
> : CD PLAY
: Impossible to measure
*
• Voltages are taken with a VOM (Input impedance 10 MΩ).
Voltage variations may be noted due to normal production
tolerances.
• Waveforms are taken with a oscilloscope.
Voltage variations may be noted due to normal production
tolerances.
• Circled numbers refer to waveforms.
• Signal path.
: AUDIO
F
: TUNER (FM/AM)
f
N
: MIC
J
: CD PLAY
: USB
E
• Abbreviation
AR
: Argentina model
AUS
: Australian model
CND : Canadian model
E4
: African model
E12
: 220 – 240 V AC area in E model
EA
: Saudi Arabia model
LA9
: Latin-American model
MY
: Malaysia model
RU
: Russian model
TH
: Thai model
HCD-SHAKE10/SHAKE30/HCDSHAKEX10/HCDSHAKEX30/HCDSHAKEX70
37
37
Ver. 1.1
SYS SET
Advertisement
Table of Contents
