Installation Space; Individual Installation; Lifting Method - LG ZRUM080LTS6 Installation Manual

Table of Contents

Advertisement

INSTALLATION SPACE

Individual Installation

During the installation of the unit, consider service, inlet, and outlet
acquire the minimum space as shown in the figures below.
Category
Installation Space
Front
Front
4 sides
are
Front
Front
walls
Front
Front
Front
Front
Front
Front
Front
Front
Rear
to
Rear
Front
Front
Front
Front
Front
Front
No limit for the
height of wall
Only 2
Front
sides
are
No limit for the height of wall
walls
Front
h1
• The height of the wall on the front side must
be 1500 mm (59 inch) or less.
A
• The height of the wall on the inlet side must
h2
B
Limitations
be 500 mm (19-11/16 inch) or less.
on the
• There is no limit to the wall on the side.
height
Inlet
Front
• If the height of the walls on the front and the
side
side
of the
side are higher than the limit, there must be
wall
45° or
more
additional space on the front and the side.
(Refer
240
- Additional Space on the front side by 1/2 of h1
(9-1/2'')
to 4
or more
- Additional Space on the inlet side by 1/2 of h2
side
walls)
- h1 = A(Actual height) - 1 500 mm (59 inch)
- h2 = B(Actual height) - 500 mm (19-11/16 inch)
50 (2) or more
[Unit : mm (inch)]
Case 1
Case 2
(10(13/32)≤Side
(Side Space
≥49(13/14))
Space≤49(13/14))
A≥10 (13/32)
A≥50 (1-31/32)
B≥300 (11-13/16)
B≥100 (3-15/16)
C≥10 (13/32)
C≥50 (1-31/32)
D≥500 (19-11/16)
D≥500(19-11/16)
A≥10 (13/32)
A≥50 (1-31/32)
B≥300 (11-13/16)
B≥100 (3-15/16)
C≥10 (13/32)
C≥50 (1-31/32)
D≥500 (19-11/16)
D≥500 (19-11/16)
E≥20 (25/32)
E≥100 (3-15/16)
A≥10 (13/32)
A≥50 (1-31/32)
B≥300 (11-13/16)
B≥100 (3-15/16)
C≥10 (13/32)
C≥50 (1-31/32)
D≥500 (19-11/16)
D≥500 (19-11/16)
E≥20 (25/32)
E≥100 (3-15/16)
F≥600 (23-5/8)
F≥500 (19-11/16)
A≥10 (13/32)
A≥50 (1-31/32)
B≥300 (11-13/16)
B≥100 (3-15/16)
C≥10 (13/32)
C≥50 (1-31/32)
D≥300 (11-13/16)
D≥100 (3-15/16)
E≥20 (25/32)
E≥100 (3-15/16)
F≥500 (19-11/16)
F≥500 (19-11/16)
A≥10 (13/32)
A≥50 (1-31/32)
B≥500 (19-11/16)
B≥500 (19-11/16)
C≥10 (13/32)
C≥50 (1-31/32)
D≥500 (19-11/16)
D≥500 (19-11/16)
F≥900 (35-7/16)
F≥600 (23-5/8)
A≥10 (13/32)
A≥50 (1-31/32)
B≥500 (19-11/16)
B≥500 (19-11/16)
C≥10 (13/32)
C≥50 (1-31/32)
D≥500 (19-11/16)
D≥500 (19-11/16)
E≥20 (25/32)
E≥100 (3-15/16)
F≥1 200 (47-1/4)
F≥900 (35-7/16)
Front
A≥10 (13/32)
A≥50 (1-31/32)
B≥500 (19-11/16)
B≥500 (19-11/16)
C≥10 (13/32)
C≥50 (1-31/32)
D≥500 (19-11/16)
D≥500 (19-11/16)
E≥20 (25/32)
E≥100 (3-15/16)
F≥1 800 (70-7/8)
F≥1 200 (47-1/4)
Front
A≥10 (13/32)
B≥300 (11-13/16)
A≥200 (7-7/8)
B≥300 (11-13/16)
E≥400 (15-3/4)
Seasonal wind and cautions in winter
• Sufficient measures are required in a snow areas or severe cold
areas in winter so that product can be operated well.
• Get ready for seasonal wind or snow in winter even in other areas.
• Install a suction and discharge duct not to let in snow or rain.
• Install the outdoor unit In such a way that it should not come in
contact with snow directly. If snow piles up and freezes on the air
suction hole, the system may malfunction. If it is installed at snowy
area, attach the hood to the system.
• The raised support platform must be high enough to allow the unit to
remain above possible snow drifts, and must be higher than the
maximum anticipated snowfall for the location.
• Where snow accumulated on the upper part of the Outdoor Unit by
more than 10 cm (3.9 inch), always remove snow for operation.
- Don't install the suction hole and discharge hole of the Outdoor
Unit facing the seasonal wind.
Remove the Rear Grille
• Remove the rear grille in snowy area.
• Make sure that heat exchanger should not be damaged.
Rear Grille

LIFTING METHOD

• When carrying the suspended, unit pass the ropes under the unit and
use the two suspension points each at the front and rear.
• Always lift the unit with ropes attached at four points so that impact
is not applied to the unit.
• Attach the ropes to the unit at an angle of 40° or less.
Locking points for
transportation ropes
Forklift Carrying Hole
Forklift Carrying Guide
15

Advertisement

Table of Contents
loading

Table of Contents