Advertisement
Digital mode
@Set the meter to the same color temperature, that was selected in your camera. Please note
that many digital cameras reproduce color better at certain color temperature settings. If
your work requires optimum color reproduction and high color fidelity, select the camera
manufacturers recommended color temperature for best color reproduction. (Please refer to
your digital camera's operating manual.)
@Depending on your preferences, you can set the color temperature from 2,500K~10,000K in
steps of 100K. (1OMK™ can be selectable in custom setting. See P41.)
@For convenience, use the preset white balance color compensation function for the digital
camera's preset white balance (See P36)
Film mode
@Set the selected color temperature of the type of film you are using.
Daylight type:
5,500K
Tungsten Type-A:
3,400K
Tungsten Type-B:
3,200K
@Depending on your preferences, you can set the color temperature from 2,500K~10,000K in
steps of 100K.
5-6. Setting the Shutter Speed (Flash Modes Only)
In flash mode, set the shutter speed before taking a flash measurement.
Lower speeds will include color from any ambient light.
Higher speeds will register more of the flash color.
Dabo ae
Turn the Jog wheel El to select the shutter speed.
A, % a fe 5
RANGE
DIGITAL
00)
Shutter speed
cO-
"s" indicates the shutter speed measured in full seconds.
AN
Ex.: 0.4s indicates a shutter speed of 0.4 seconds,
while 60 indicates a shutter speed of 1/60 of a second.
Ote)
@Select a shutter speed range that will synchronize with your camera and flash system.
@If the shutter speed setting is changed in the meter, all previous measured data will be deleted.
c-500R
A
6:
oy
9)
Neus
@Shutter speeds can be changed in increments of Full, 1/2 and 1/3 steps in the custom settings.
(See P41)
@Shutter speeds are selectable from 1 to 1/500 of a second. Special shutter speeds of 1/75, 1/80,
1/90, 1/100, 1/200 and 1/400 of a second are provided after you go pasted 1/500th of a second.
15
E 224m
Sor
Advertisement
