Goddess RSD 084 GW8SS Instruction Manual page 53

Space Requirement
• Keep enough space of door open.
• Keep at least 50mm gap at two sides.
Leveling the unit
To do this adjust the two leveling feet at front of the unit.
If the unit is not level, the doors and magnetic seal alignments will
not be covered properly.
Note: Above pictures are for reference only.
Positioning
Install this appliance at a location where the ambient temperature corresponds to the climate
class indicated on the rating plate of the appliance:
Location
The appliance should be installed well away from sources of heat such as radiators, boilers,
direct sunlight etc. Ensure that air can circulate freely around the back of the cabinet. To ensure
best performance, if the appliance is positioned below an overhanging wall unit, the minimum
distance between the top of the cabi-net and the wall unit must be at least 100 mm. Ideally,
however, the appliance should not be positioned below overhanging wall units. Accurate leveling
is ensured by one or more adjust-able feet at the base of the cabinet.
WARNING! It must be possible to disconnect the appliance from the mains power supply;
the plug must therefore be easily accessible after installation.
Electrical connection
• Before plugging in, ensure that the voltage and frequency shown on the rating plate
correspond to your domestic power supply. The appliance must be earthed. The power
supply cable plug is provided with a contact for this purpose. If the domestic power supply
socket is not earthed, connect the appliance to a separate earth in compliance with current
regulations, consulting a qualified electrician.
• The manufacturer declines all responsibility if the above safety precautions are not
observed.This appliance complies with the E.E.C. Directives.
Climate class Ambient temperature
SN +10 °C to +32 °C
N +16 °C to +32 °C
ST +16 °C to +38 °C
T +16 °C to +43 °C
ENG - 53
ENG