Table of Contents
Advertisement
I Troubleshooting Guide
MP3i/WMA source
Cannot play an MP3/WMA,
■ The media is scratched or dirty.
Clean the media, referring to the Disc cleaning of
the section on.
The sound skips when an MP3/WMA is being
played.
■ The media is scratched or dirty.
Clean the media, referring to the Disc cleaning of
the section on,
■ The recording condition is bad.
Record the media again or use another media.
The MP3/WMA track time is not displayed correctly.
■
—
Record in confonnity
with
the 1D3 tag version
1 ,x.
Also, the display
may
be Incorrect if an
UP3/\NMA
file uses the ID3 tag v1 .x standard and if this
standard has been expanded after production of
the machine softvvare.
TROUBLE
CORRECTIVE ACTION
■ No Power -^-
■ No Picture -
■ Stopped picture-
■ The playback picture is poor.-
■ No color.-
■ The remote control doesn't work properly.-
■ ERROR-DISC is displayed on the screen,-
■ ERROR-DISC Check Regional Code is displayed on-
the screen.
■ No funcion with the remote control.-
■ Unable to insert Disc.-
■ No Function With all buttons on the unit & remote control. —
■ Check Point.-
Check that DC power cable is connected properly.
1. Make sure that the equipment is connected properly.
2. Check that the connected monitor is turned on.
1. Check that the video cable is connected.
2. Check that the monitor is turned on.
Clean the disc
Adjust the video system by changing TV output mode
{AUTO, PAL, NTSC)
Remove any obstacles between the remote controller and
remote control sensor of the unit, Operate the remote con¬
trol at a closer distance to the unit.
1. Turn the power off, then turn it on.
2. Turn the power off, disconnect the power plug, then
reconnect it.
Check in which redion the DVD Disc can be played.
The DVD Disc is not available of the region code of the
DVD Disc is not in conformity to the one of the unit.
Check the batteries and make sure that the batteries are
fresh & new, or have enough battery life.
1. Check if the protection screw was removed before
installation of the unit. (Only at the first insertion after
installation.)
2. Pull out Disc and wait for 3 seconds, and insert Disc again.
Press the Hard Reset Key.
When a disc is brought from a cold environment to a hot
one, there may be steam on the face of the disc, or water
will appear on the pickup lens, it will affect the play.
1. Remove the disc from the DVD player.
2. Turn on the power and leave it on for an hour to vaporise
the condensation.
Advertisement
Table of Contents
