Table of Contents
Advertisement
3. Handle Assembly (Type A)
VivaCart has 2 sizes of handles (that can be
mounted at the front or rear of the cart. Cart
handles are designed with a long side and a
short side, and one or both can be installed
depending on preference. When both handles
are installed, the small notch that is created
can be used to aid in cord/hose management.
To install handles, the long side goes on the
left mount, and the short side is attached to
the right mount (see fig. 3.1). With the handle
in the correct upright orientation, mount the
handle using a hex screw (AA), with lock
washer (AB), and washer (AC) (see fig. 3.2) and
secure the accessory into the hole (hand
tighten). Next, use a hex tool (AG) to tighten
the screw.
4. Storage Basket Assembly (Type B)
The optional VivaCart Storage Basket (VC-B-
VSB) can only be mounted on the side of the
cart with basket hook mounts (see fig 4.1).
To install, place the wire loops near the
opening of the basket (see fig. 4.2) inside the
basket hook mounts (see fig. 4.1) and push
down to lock into place, making sure that the
lower hooks (see fig. 4.3) fit over the middle
side mounting zone.
Wire Loops
Lower Hooks
Fig. 4.2 Storage basket
wire loops and lower hooks
LBL-81 V0
Long side
Fig. 3.1. Mounting handle to VivaCart
AA
Fig. 3.2. Securing mounting screws.
Fig. 4.1 Basket hook mounts
Fig. 4.3 Storage Basket wire loops
inserted to basket hook mounts
13
Short side
CardioQuip
AB
AC
©2023 CardioQuip, LLC
Advertisement
Table of Contents
