Table of Contents
Advertisement
2. Swivel Caster Assembly
Begin assembly by attaching the swivel casters. VivaCart comes standard with four swivel casters: two (2)
Directional Lock Casters, VC-R-DLC, and two (2) Total Lock Casters, VC-R-TLC. For best results and added
control, install one directional lock caster on both the front and rear of the cart (see fig. 2.1). Note:
VivaCart may be equipped with all directional lock casters for an additional cost.
To assemble casters, follow the steps below:
Directional Lock Casters (VC-R-DLC) Assembly
1. Activate the green tab on both VC-R-DLC
Directional Lock Casters and rotate the
caster until the lock engages. Hold up the
caster to the mounting block on the drawer
side and ensure the lock is engaged parallel
to the direction of cart motion. If the wheel
is locked perpendicular to the direction of
motion, try the other wheel.
2. Tilt the cart on its side and hand-tighten the
five Hex screws (AA) with lock washer (AB)
and washer (AC) in that order (see fig. 2.2).
Secure all five screws (two on each side and
one on bottom).
3. Press the caster mounting leg firmly into the
cart body and tighten with a hex wrench
(VC-AH-HXT) from the top down.
4. Repeat until both directional lock casters are
secure.
LBL-81 V0
VC-R-TLC
FRONT
VC-R-DLC
Fig. 2.1 Recommended caster orientation with directional lock casters at
front and rear of cart.
REAR
Directional lock caster and
AA
Fig. 2.2 Securing mounting screws.
11
VC-R-TLC
VC-R-DLC
VC-R-DLC
mount
AB
AC
©2023 CardioQuip, LLC
Advertisement
Table of Contents
