Table of Contents
Advertisement
Total Lock Caster (VC-R-TLC) Assembly
1. With the cart still on its side, place the Total
Lock Caster on the mounting block and
hand-tighten the five Hex screws (AA) with
lock washer (AB) and washer (AC) in that
order (see fig. 2.2). Secure all five screws (two
on each side and one on bottom).
2. Press the caster mounting leg firmly into the
cart body and tighten with the hex wrench
(VC-AH-HXT) from the top down.
3. Repeat until both total lock casters are
secure.
Note: If casters are not rolling level once installed, check to ensure all casters are engaging. If
one or more casters is not engaging the ground, loosen bottom M8 screw and four (4) side
screws on the wheel mount and press firmly down on the wheel mount to lower the mounting
position. Next, tighten the four (4) side screws in place before tightening the lower screw.
LBL-81 V0
Total Lock Caster and mount
12
VC-R-TLC
©2023 CardioQuip, LLC
Advertisement
Table of Contents
