L&W SC-180 ES Operating Instructions Manual page 58

M A I N T E N A N C E A N D S E R V I C E
Replace in- and outlet valve 1st stage
Note
i
The figures can differ from the delivered parts.
Replace the inlet and outlet valve 1st stage as follows:
• Insert lower valve gasket (Fig.1).
• Insert upper valve gasket (Fig.2).
• Insert in– and outlet valve. CAUTION: Observe correct position
between valve centre hole and valve head locating pin (Fig. 2+3).
• Place valve head carefully on top of the cylinder (take care to
keep valve in place) (Fig.4)
• Tighten valve head screws crosswise.
• Set tight connecting nut and fix vent hose to air intake housing.
Don´t forget to fix spring wire clamp.
Inlet and outlet valves change 1st stage is now completed
Fig. 2 - Correct position of inand
outlet valve
LW SC-180 ES / LW SC-250 ES
Version: 09.12.2022
Fig. 3 - Correct position of in-and
outlet valve
.
Fig. 1 - Lower valve gasket
Fig. 4 - Take care to kkeep valve in
place
A
Seite A - 56