Philips AVENT SCY670 Manual

Baby Bottle
Biberón
Biberon Biberon
SCY670, SCY673,
SCD657
www.philips.com/avent
Philips Consumer Lifestyle B.V.
Tussendiepen 4, 9206 AD Drachten, The Netherlands /
les Pays-Bas / Países Bajos
Trademarks are the property of Koninklijke Philips N.V. /
Les marques commerciales sont la propriété de Koninklijke Philips N.V. /
Las marcas comerciales son propiedad de Koninklijke Philips N.V.
© 2023 Koninklijke Philips N.V.
All rights reserved. / Tous droits réservés. / Todos los derechos reservados.
3000.096.8564.3 (21/11/2023)
1 2 3
6
7
4 5
FSC
300009685643
ENGLISH
Read all instructions carefully before use. Keep the user manual
and product packaging for future reference.
For your child's safety and health
WARNING!
- Continuous and prolonged sucking of fluids will cause tooth
decay.
- Always check food temperature before feeding.
- Throw away at the first signs of damage or weakness.
- Keep components not in use out of the reach of children.
- Never attach to cords, ribbons, laces or loose parts of clothing.
The child can be strangled.
- Never use feeding teats as a soother.
- Always use this product with adult supervision.
It is not recommended to use a microwave to warm up baby
food or drinks. Microwaves may destroy valuable nutrients in
food/drinks and may produce localized high temperatures. If
you decide to use the microwave, take extra care to stir heated
food/drinks to ensure even heat distribution and check the
temperature before serving. Only place the container in the
microwave, without the screw ring, AirFree vent, teat and cap.
Do not allow children to play with small parts or walk/run while
using bottles. Always discard any breast milk that is left over at
the end of a feed. Inspect before each use and pull the feeding
teat in all directions. Throw away at the first signs of damage
or weakness.
AirFree vent
The AirFree vent keeps the teat full of milk during feeding, even
while the bottle is held horizontally. This supports an upright
feeding position for your baby in order to reduce air ingestion.
This helps reduce common feeding issues including wind and
reflux.
Before first use
Disassemble all parts, clean and then sterilize the parts by
placing in boiling water for 5 minutes or sterilize by using a
Philips Avent sterilizer. This is to ensure hygiene.
Assembly
Make sure that the feeding teat is fully pulled through the screw
ring (Fig. 1, 2). Place the AirFree vent in the bottle before you
assemble the screw ring and teat (Fig. 3).
Warning: If you prepare formula, make sure that all the
formula is fully dissolved to avoid blocking the AirFree
vent.
Note: Before feeding your baby, make sure that you fill the teat
with milk by turning the bottle (with the AirFree vent) upside
down. Then rotate the bottle for feeding so that the AirFree vent
points upwards, in line with your baby's nose (Fig. 6).
Philips Avent bottles can also be used without the AirFree vent.
Cleaning and storage
Clean all parts before each use to ensure hygiene. After each
use, disassemble all parts, wash in warm, soapy water, remove
any food residues and rinse thoroughly. If you use a brush to
clean the tip of the feeding teat, clean it as carefully as possible
to avoid damage. Then sterilize using a Philips Avent sterilizer
or boil for 5 minutes. Make sure that you wash your hands
thoroughly and that the surfaces are clean before contact with
sterilized components. During sterilization with boiling water,
prevent the parts from touching the side of the pot. This can
cause irreversible product deformation, defect or damage that
Philips cannot be held liable for. Food colorings may discolor
parts. This product is dishwasher safe. Do not place the product
in a heated oven. Do not bring the bottle parts in contact with
or place on surfaces with abrasive or antibacterial cleaning
agents. We recommend replacing feeding teats every 3 months.
Keep parts in a dry, covered container. Do not leave a feeding
teat and/or AirFree vent in direct sunlight or heat, or leave in
disinfectant (sterilizing solution) for longer than recommended,
as this may weaken the parts.
Compatibility
The AirFree vent works with all Philips Avent bottles, except
glass bottles and except Natural teats of the previous design
(Fig. 7). Replacement teats are available separately. To learn
more about choosing the right teat for your baby, visit us at
www.philips.com/avent.
Support
If you need information or support, please visit
www.philips.com/support.