Gravely Pro-Master 260 Owner's/Operator's Manual page 34

ADJUSTING UNIT TO TRACK
STRAIGHT
(Figure 24)
WARNING: Prior to adjusting the
tracking of the unit, shut off
engine, engage parking brake,
and remove the ignition key.
Check and adjust tire pressure. Increase
pressure on side unit tracks to. DO NOT
exceed maximum recommended tire
pressure. See Specifications on page 39 for
correct tire pressure.
If tire pressure adjustment does not solve
tracking problem, adjust the limiter bolts on
the stop bracket (Figure 24). Front bolts
adjust forward and rear bolts adjust reverse.
Lengthen the limiter bolt (move closer to
lever) on side which is too fast.
3
2
1
1. Limiter Bolt
2. Jam Nut
3. Steering Lever
4. Stop Bracket
2
Figure 24
STEERING LEVER HANDLE
HEIGHT ADJUSTMENT
(Figure 25)
The handles have three height positions.
1
1. Spacer
2. Handle
3. Steering Lever
1. Remove spacer, handle, and eccentric
spacer from steering lever.
NOTICE: Position the right and left handles at
the same height.
2. Install spacer, handle, and eccentric
spacer in the appropriate height position.
1
Do not tighten nut holding eccentric
spacer.
3. Turn eccentric spacer until the right and
left handles are the same height. Tighten
nut.
4
PARKING BRAKE ADJUSTMENT
The parking brake might need adjustment
over time and after new brake pads have
been installed.
NOTICE: After installing new brake pads in
calipers, they must be burnished by driving
for a short distance (about 100 feet) with the
brake on. To do this, bring parking brake lever
part-way up while driving normally (in a
straight line).
EN - 34
2
Position 1
Position 2
Position 3
3
Figure 25