atd models ATD033 Instruction Manual
  1. Manuals
  2. Brands
  3. atd models Manuals
  4. Toy
  5. ATD033
  6. Instruction manual

atd models ATD033 Instruction Manual

Traditional market stall - style 2
Hide thumbs
1
2
3
4
Table of Contents

Advertisement

Quick Links

Download this manual
ATD033 - OO (1:76 Scale)
Traditional Market Stall - Style 2
- Instruction Manual

Tools Required

Modellers Knife (with a fresh blade)
Cutting Mat
Modelling Glue (we recommend Deluxe Materials Roket Card Glue)
Fine Tip Applicator
Low-tac Masking Tape
Clips / Clamps

Tips

Prior to starting your build, we recommend reading through the instructions to
familiarise yourself with the build style of the kit.
We recommend painting any white edges as you remove the components from
the sheet to improve the finished look. We advise watercolour paints for the best
finish.
Each component is held in the sheet using score lines, indicated by a scissor
symbol. To remove the component from the sheet, carefully run the tip of your
modelling knife through the score line.
Remove each component as it is required to prevent losing or mixing it up with
another component.
Ensure that glue is distributed evenly and not too close to the edge as it may ooze
out when pressure is applied.
Use low-tac masking tape, clamps and weights to aid the assembly process.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ATD033 and is the answer not in the manual?

Questions and answers

Related Manuals for atd models ATD033

Summary of Contents for atd models ATD033

  • Page 1 ATD033 - OO (1:76 Scale) Traditional Market Stall - Style 2 - Instruction Manual Tools Required Modellers Knife (with a fresh blade) Cutting Mat Modelling Glue (we recommend Deluxe Materials Roket Card Glue) Fine Tip Applicator Low-tac Masking Tape Clips / Clamps...
  • Page 2 1. Detach component A and place it face down on your work surface. Then, locate the glazing sheet, cut out the three windows and glue them into position. Optional: Carefully run the blade of your modelling knife down the scored line on the door to achieve an ‘open’...
  • Page 3 5. Apply glue to two of the outer 6. Detach component C and fold edges of component B. Then, the crease lines. Then, apply glue carefully slide component B to the two tabs and position it inside component A. below the serving window, between the two counters.

Table of Contents