Advertisement
Available languages
Available languages
EN
Safety Instructions
Important Instructions
Important instructions and warning notices are located on the machine by means of symbols:
Before you start working, read the operating instructions of the machine.
Work concentrated and carefully. Keep your workplace clean and avoid dangerous situations.
For your safety, take precautions.
Wear hearing protectors.
Wear goggles.
Wear protective gloves.
Wear a dust mask.
Safe work with the machine is only possible if you read this operating instruction and the safety instructions completely and follow the instructions contained
strictly.
Additionally, the general safety instructions of the leaflet supplied with the tool must be observed. Prior to the first use, the user should absolve a practical
training.
If the mains cable gets damaged or cut during the use, do not touch it, but instantly pull the plug out of the socket. Never use the tool with damaged mains
cable.
The tool must neither be wet nor used in humid environment.
- Do not use the tool near explosive materials (petrol, dilution).
- Do not work with materials containing asbestos.
- Prior to every use, check the tool and its cable and plug. Have damages only repaired by specialists, Insert the plug into the socket only when the tool switch
is off.
- Plug and switch the machine off if it is not under supervision, in case of putting up and stripping down the machine, in case of voltage drop or when fixing
or mounting an accessory.
- Switch the machine off if it stops for whatever reason You avoid that it starts suddenly and not under supervision.
- Before starting your work, check the proper seat of the cutting bit and the individual stars.
- Check the milling head before every use. Do not use damaged or sluggishly running milling stars.
- Make sure that the tool was mounted properly, and let it run idly in a safe position for 30 seconds. Stop the tool immediately if you found considerable
vibrations or other defects.
- Don't use the machine if a part of the housing is damaged or in case of damages on the switch, the cable or plug.
- Electrical tools have to be inspected visually by a specialist in regular intervals.
- After interruption of your work, restart the tool only after having made sure that the milling head and the stars are moving freely.
- Do not touch rotating parts.
- Persons under 16 years are not supposed to use the tool.
- Keep the handles dry, clean and free of oil and grease.
- Attention! The milling head still runs for a little while after the machine was switched off.
- When working with the machine, wear ear protectors, dust mask and goggles.
- Always hold the machine with both hands.
- Consider the tool's reaction torque.
- Make sure that persons in the work space are not endangered by particles flying around.
- In order to avoid the star holder and the milling stars get damaged, work very carefully on edges, corners or extreme transition.
- Do not work on surfaces with steel reinforcements which lie open.
Electrical connection
First, check the correspondence between voltage and frequency against the data mentioned on the identification plate. Voltage differences from + 6 % to
- 10 % are allowed.
The tool includes a start-up speed limiter to prevent fast expulsion fuses from unindented responding.
2
WWW.NIKOLAOUTOOLS.COM
Advertisement
