Salus Karlstad II Owner's Manual page 3

WARNING!
Do not place anything combustible close to heater, above the heater, and on both
sides of the heater. This includes but not limited to towels, lights, robe hooks,
accessories, etc. Nothing should be on the same wall as your heater that is
combustible.
FOLLOW ALL INSTRUCTIONS AND BE CAUTIOUS OF SAFETY SYMBOLS. All electrical
wiring must be performed by a qualified licensed electrician. While the barrel sauna comes in
different sizes and features, the information within this manual is applicable to each.
High Voltage Symbol: Be cautious as there is the presence of a high voltage current that flows
through the equipment!
General Caution Symbol: Be cautious as the equipment uses electrical current that can
cause serious injury.
Please read this Owner's Manual thoroughly before use. This will allow the user to
1.
become familiar with the operation of the control system. Please keep the Owner's
Manual available for future reference. If any technical assistance or repairing is
needed, please contact the manufacturer.
2. The sauna can be installed outdoors. Please note that water will seep between the
staves due to the porous nature of the wood. When not in use and placed outdoors, a
rain cover is recommended to cover the sauna room if your model does not come with
an actual outdoor roof. Please note that water seepage will not hurt the wood and will
usually dry quickly due to the heated environment. If you want to keep the sauna
completely dry, you will need to install the sauna under a covered structure.
3. To reduce the risk of electric shock and/or fire, do not expose the control system to
direct water contact or rain. Do not open the cover to the control system as there are
high tension fittings that can be dangerous. Only dealer authorized qualified
technicians should make any needed or necessary repairs at any time.
4. Any repairs, alterations, or modifications to the control system are not authorized
unless by an approved repair technician. Any non-authorized repairs, alterations, or
modifications can lead to serious injuries and can cause the unit to work outside its
intended specifications parameters.
5. Any non-authorized repairs, alterations, or modifications will void the warranty.
6. Before connecting the unit to a power source, please make sure that all wires, cords,
and connections are connected properly. If there are any concerns, please consult
with a certified electrician.
7. Make sure that the sauna is placed in a well-ventilated area. It should not be place in
an area with other thermal-radiating objects. Make sure that the vents will not be
obstructed for proper air flow.
8. When the equipment is not going to be used for an extended period of time, you can
shut the main power source to the sauna or turn OFF the dedicated circuit breaker.
3