Salus Karlstad II Owner's Manual page 15

6. Continuing to Install Bottom Half of Acrylic Rear Panel
You will need to locate the two wood planks that are used to connect the bottom and
top acrylic rear wall sections. Use the provided screws to attach the two horizontal
wood planks to each other (one on the interior and one on the exterior) through the
acrylic rear wall lower section. Also, screw the exterior horizontal wood plank to the
applicable stave. Be sure not to over tighten the screws. Only install the bottom
screws. See figure 6.
A
Interior
figure 6
7. Placing Top Half of Acrylic Rear Panel
The top half of the acrylic rear wall will need to be lifted up and placed between the two
wood planks which were installed in section 6. Use one of the staves to hold the
acrylic rear panel to the front wall panel at the top. One adult will need to continue to
hold the top half of the acrylic rear panel to keep it in place. Use the provided
screws to attach the horizontal wood planks to the top half of the acrylic rear panel as
was done to the bottom half of the acrylic rear panel. Be sure not to over tighten the
screws. See figure 7 and figure 7a.
Exterior
B
C
15