Salus Karlstad II Owner's Manual page 14

rubber mallet. Keep the staves snug and tight. The two staves with the pre-drilled
th
holes will be the 7 staves (not counting the first installed stave) on the right and left.
These two staves will need to be screwed down to the support cradles. Use the
provided M5*50 screws to attached these staves to the support cradles. Do not use
nails/screws on any staves you just installed except for the first three. See figure
4.
M5*50
figure 4
5. Installing Front Wall Panel and Bottom Half of the Acrylic Rear Wall
First, locate the three pieces of the front wall panel. See figure 5. Use the provided
screws to attached the front wall panel together. Next, two adults will need to lift the
front wall panel up and into the groove on the staves. Use the leveler to make sure that
the front wall is level after installing onto the staves.. One adult will need to continue to
hold the front wall panel in place. Next, two adults will need to install the bottom half of
the acrylic rear wall. The bottom half of the acrylic rear wall will need to sit in the
groove on the stave just like the front wall panel. Make sure that the bottom half of the
acrylic rear panel is positioned in the groove equally and use the leveler to make sure
the acrylic rear panel is level after installing into the staves.. Next, you will need to use
two of the staves to hold both the front wall panel and bottom half of the acrylic rear
wall in place. You can now add the remaining staves as seen in figure 5b.
figure 5
figure 5a figure 5b
14