Table of Contents
Advertisement
Out door Unit Dimensions
W
H
mm
inch
mm
inch
805
31-11/16 554
21-13/16 330 13
890 35
673
26-1/2
946
37-1/4
810
31-29/32 410 16-5/32
952
37-1/2
1333
52-1/2
Rows of series installation
The relations betw een H, A and L are as follow s.
L
L ≤ 1/2H
L ≤ H
1/2H < L ≤ H
Can not be installed
L > H
H
Page 30
30
(unit : mm/ inch)
M ount ing Dimensions
D
A
B
mm
inch
mm
inch
mm
511
20-1/8
317
12-1/2
342 13-15/32
663
26-1/8
354
13-15/16
673
26-1/2
403
15-7/8
415 16-11/32
634
24-35/36
404
15-29/32
A
25 cm / 9-13/16in or more
30 cm / 11-13/16in or more
If you will install the unit on the ground
or on a concrete mounting platform,
do the following:
inch
1. Mark the positions for four expansion bolts
based on dimensions chart.
2. Pre-drill holes for expansion bolts.
3. Place a nut on the end of each expansion bolt.
4. Hammer expansion bolts into the pre-drilled
holes.
5. Remove the nuts from expansion bolts, and
place outdoor unit on bolts.
6. Put washer on each expansion bolt, then
replace the nuts.
7. Using a wrench, tighten each nut until snug.
WARNING
WHEN DRILLING INTO CONCRETE, EYE
PROTECTION IS RECOMMENDED AT
ALL TIMES.
If you will install the unit on a wall-mounted
bracket , do the following:
L
CAUTION
Make sure that the wall is made of solid brick,
concrete, or of similarly strong material.
The wall must be able to support at
least four times the weight of the unit.
1. Mark the position of bracket holes based on
dimensions chart.
2. Pre-drill the holes for the expansion bolts.
3. Place a washer and nut on the end of each
expansion bolt.
4. Thread expansion bolts through holes in
mounting brackets, put mounting brackets
in position, and hammer expansion bolts into
the wall.
5. Check that the mounting brackets are level.
6. Carefully lift unit and place its mounting feet
on brackets.
7. Bolt the unit rmly to the brackets.
8. If allowed, install the unit with rubber gaskets
to reduce vibrations and noise.
Advertisement
Table of Contents
