Table of Contents
Advertisement
dishwasher safe
drip tray grille (A12)
milk carafe (E)
13.2 Cleaning the internal circuit
If the machine is not used for more than 3/4 days, it is strongly
advisable, before using it after such a break, to empty the tank
(A9) and refill it with fresh drinking water, then switch on and
run 2/3 rinse cycles selecting the "Rinse" function (section "6.1
Rinsing").
Please note:
It can happen, during the rinse procedure, that water will find
its way into the grounds container (A10): this is quite normal.
13.3 Cleaning the coffee grounds container
When "Empty grounds container" appears on the display, the
grounds container must be emptied and cleaned. The machine
cannot make coffee again until the grounds container (A10) has
been cleaned. The machine will display the message indicating
the need to empty the grounds container 72 hours after the first
coffee has been prepared, even if the container is not full (for the
72 hours to be calculated correctly, the machine must never be
disconnected from the mains power supply).
Important! Danger of scalding
If you make a number of milk-based drinks one after the other,
the metal cup tray (A11) becomes hot. Wait for it to cool down
before touching it and handle it from the front only.
To clean (with the machine on):
1. Remove the drip tray (A14) and grounds container (A10)
(fig. 27);
hand wash only
drip tray (A14)
coffee grounds container
(A10)
cup tray (A11)
water tank (A9)
removable infuser (A6)
27
2. Empty the drip tray and the grounds container and clean
thoroughly with a brush to remove all residues that may
have collected on the bottom.
3. Put the drip tray complete with grille and grounds contain-
er back in the appliance.
Important!
•
When removing the drip tray, the coffee grounds container
must always be emptied, even if it has not filled up notice-
ably. If this is not done, it can happen that when further
coffees are prepared, the grounds container will fill up
more than expected and clog the machine.
•
The grounds container on certain models is made up of two
distinct parts: after cleaning, reassemble the parts before
returning the container to the machine.
13.4 Cleaning the drip tray and drip tray grille
Important!
The drip tray (A14) is fitted with a level indicator (A13) (red)
showing the amount of water it contains (fig. 28).
Before the indicator protrudes from the cup tray (A11), the drip
tray must be emptied and cleaned, otherwise the water may
overflow the edge and damage the appliance, the surface it
rests on or the surrounding area. To remove the drip tray, pro-
ceed as follows:
1. Remove the drip tray complete with grille (A12) and tray,
and the grounds container (A10) (fig. 24);
2. Check the condensate drip tray, which is coloured red (A15)
and empty if necessary;
3. Check the red-coloured condensate tray;
4. Remove the cup tray (A11) and drip tray grille (A12), then
empty the drip tray and grounds container and wash all
components.
5. Put the drip tray complete with grille, tray and grounds
container back in the appliance.
Important!
When removing the drip tray, the coffee grounds container must
always be emptied, even if it has not filled up noticeably. If this
is not done, it can happen that when further coffees are pre-
pared, the grounds container will fill up more than expected and
clog the machine.
16
28
Advertisement
Table of Contents
Troubleshooting
