ResMed AirSense 11 User Manual page 25

Sound power level measured according to ISO 80601-2-70:2015 (CPAP mode):
Device with SlimLine and HumidAir 11 humidifier tub
(HumidAir 11 humidifier tub 1/2 filled)
Device with SlimLine and Side cover
Physical Dimensions
Dimensions (H x W x D) with HumidAir 11 humidifier tub 94.5 mm x 259.4 mm x 138.5 mm
Dimensions (H x W x D) with side cover
Air outlet:
Weight - device and HumidAir 11 Cleanable humidifier
tub:
Weight - device with side cover
Housing construction:
Hot plate - Material:
Water capacity:
Time between each refill of the humidifier tub:
Humidifier tub - Material:
65W power supply unit
AC input range
DC output
Typical power consumption
Peak power consumption
Class of equipment
Environmental conditions
Operating temperature
Operating humidity
Operating altitude
Storage pressure/Storage altitude
Storage and transport temperature
Storage and transport humidity
Air Filter
Standard:
Hypoallergenic:
Electromagnetic compatibility
The AirSense 11 complies with all applicable electromagnetic compatibility requirements (EMC) according to IEC 60601-1-2:2020,
for residential, commercial and light industry environments.
Portable and mobile RF communications equipment should be used no closer to any part of the machine, including cables, than the
recommended 10 cm separation distance.
The AirSense 11 has been designed to meet EMC standards. However, should you suspect that the device performance (eg.
pressure or flow) is affected by other equipment, move the device away from the possible cause of interference.
Information regarding the electromagnetic emissions and immunity of this ResMed device can be found in
ResMed.com/downloads/devices.
22
35 dBA with uncertainty of 2 dBA
33 dBA with uncertainty of 2 dBA
94.5 mm x 236.8 mm x 138.5 mm
The 22 mm conical outlet connector complies with EN ISO 5356-1:2015
1130 g
1142 g
Flame retardant engineering thermoplastic
Stainless steel
380 mL
> 8 hours ±0.5 hours (tested at 23 ±2°C)
Injection moulded plastic, stainless steel and silicone seal
100-240V, 50-60Hz, 2.0A
115V, 400Hz, 1.5A (for aircraft use)
24 V 2.71A
56.1W (111.5VA)
73.2W (137.6VA)
Class ll
+5°C to +35°C
Note: The airflow for breathing produced by this therapy device can be
higher than the room temperature. Under extreme ambient temperature
conditions (40°C) the device remains safe.
10 to 95% relative humidity, non-condensing
Sea level to 9,870' (3,010 m); air pressure range 1060 hPa to 700 hPa
1060 to 700 hPa
-25°C to +70°C
5 to 95% relative humidity, non-condensing
Material: Polyester non woven fibre
Average arrestance: >75%, when tested to EN779.
Material: Blended synthetic fibres in a polypropylene carrier
Efficiency: >80% (average) when tested to EN13274-7.
Note: The use of a ResMed approved hypoallergenic filter will result in a
small reduction in the accuracy of the delivered pressure at high leaks.