Toyota Dyna100 EE 2012 Manual page 36

30
SEATS, SEAT BELTS, STEERING WHEEL AND MIRRORS
—3−point type
Adjust the seat as needed (driver's seat
only) and sit up straight and well back
in the seat. To fasten your belt, pull it
out of the retractor and insert the tab
into the buckle.
You will hear a click when the tab locks
into the buckle.
The seat belt length automatically adjusts
to your size and the seat position.
The retractor will lock the belt during a
sudden stop or on impact. It also may
lock if you lean forward too quickly. A
slow, easy motion will allow the belt to
extend, and you can move around freely.
If the seat belt cannot be pulled out of the
retractor, firmly pull the belt and release
it. You will then be able to smoothly pull
the belt out of the retractor.
Dyna100/150_EE
CAUTION
After inserting the tab, make sure
D
the tab and buckle are locked and
the belt is not twisted.
Do not insert coins, clips, etc. in
D
the buckle as this may prevent you
from properly latching the tab and
buckle.
If the seat belt does not function
D
normally, immediately contact any
authorized Toyota dealer or repairer,
or another duly qualified
equipped professional. Do not use
the seat until the seat belt is fixed,
because it cannot protect an adult
occupant or your child from death
or serious injury.
and