Toyota Dyna100 EE 2012 Manual page 125

INFORMATION BEFORE DRIVING YOUR TOYOTA
DPF system indicator light
If the DPF system indicator light comes
on, the deposit built up in the filter needs
to be regenerated. To regenerate the filter,
the following driving methods are recom-
mended:
Driving continuously (for example, driv-
D
ing at approximately 60 km/h [36 mph]
for approximately 20 minutes).
Avoiding short trips, or by driving con-
D
tinuously (leaving the engine running
for long periods of time).
Perform manual regeneration. (with the
D
DPF system manual
switch)
The DPF indicator light will extinguish
when regeneration is complete. However,
if this driving cannot be carried out, or if
the light does not extinguish even after
driving, have the vehicle inspected by any
authorized Toyota dealer or repairer, or
another duly qualified and equipped pro-
fessional immediately.
When driving, pay sufficient attention to
weather, road condition, terrain and traffic
conditions, and drive according to traffic
laws.
Dyna100/150_EE
If the DPF system indicator light flashes
perform the following operations:
*
: The deposit built up in the filter needs
to be regenerated.
Without the DPF system manual regen-
eration
spected by any authorized Toyota dealer
or repairer, or another duly qualified and
equipped professional immediately.
With the DPF system manual regenera-
tion switch—Perform manual regeneration
or have the vehicle inspected by any au-
thorized Toyota dealer or repairer, or
another duly qualified and equipped pro-
fessional immediately. If regeneration is
not performed and you continue to drive
for a while, the malfunction indicator light
will come on. When the malfunction indi-
cator comes on, manual regeneration can-
not be performed.
Under the following driving conditions, the
DPF system indicator light may come on
earlier than normal.
When only driving at low speeds (for
D
example 20 km/h [12 mph] or below).
If the engine is turned on and off fre-
D
quently (for example, the engine is not
regeneration
left running for more than 10 minutes
at a time).
*
: Differs in accordance with weather,
driving condition, etc.
For the manual regeneration procedure,
refer to the following instructions.
switch—Have the vehicle in-
*
:
119
*
,