Advertisement
Quick Links
Technical Practice
Why use a service bureau? Now you can own your own "International Call Back" unit!
By installing the RAD-AMP/RAD-INTL
combination in the United States on a
Centrex line or C.O. line with "Call
Transfer" features, dramatic savings can
be realized over calls originating from
foreign countries.
When your foreign office calls the RAD-AMP and hangs up in less than five rings, the
RAD-AMP immediately calls back. If the line is busy, the unit redials until a connection
is made. Your foreign office can then enter a security code plus the number to be
dialed at U.S telephone rates. When the call is transferred, the RAD-AMP is free to
accept new calls. The "call back" number can also be changed remotely to allow
roaming capabilities.
Features
• Audio amplifier
• Roaming capability
• Programmable security code
• Remote night switch capability
• Busy and ring detection
• Non-volatile memory (No batteries required)
• Programmable access code
• 20 digit phone number memory
Made in the U.S.A.
Replace the existing software in the RAD-AMP with the RAD-INTL software by following steps 1-8 below.
Important: Electronic components are sensitive to static electricity.
Personnel and the work area should be grounded before handling the
RAD-AMP and its components.
1. Be sure that the AC power and the phone line have been
disconnected.
2. Remove the two phillips screws on the bottom of the unit.
3. Remove the top half of the chassis.
4. Carefully remove the Micro. by prying it out of the socket.
5. Install the new Micro. into the socket, with the indent
(notch) in the direction as shown in the Diagram 1.
6. Move jumper JP1 to position shown.
7. Reinstall the chassis cover and replace the two screws.
8. Reconnect AC power and phone line.
Telecommunication Peripheral Products
Provide International Call Back
http://www.VikingElectronics.com
E-mail...Sales@VikingElectronics.com
Installation
Specifications
Description: One 18 pin microcontroller chip
Note: For complete specifications on the RAD-AMP, retrieve
Fax Back Document 415.
Important: When using the RAD-INTL software, this
technical practice must be used for all programming and
installation instructions.
Sales...(715) 386 - 8861
Diagram 1
RAD-INTL
International Call
Back Kit
May 12, 1999
JP1
258288 REV D
Advertisement
Related Manuals for Viking RAD-AMP
Summary of Contents for Viking RAD-AMP
-
Page 1: Specifications
When your foreign office calls the RAD-AMP and hangs up in less than five rings, the RAD-AMP immediately calls back. If the line is busy, the unit redials until a connection is made. Your foreign office can then enter a security code plus the number to be dialed at U.S telephone rates. - Page 2 When a phone number has been entered, the RAD-AMP will flash and dial the phone number. If the RAD-AMP detects a ring at the phone number, the RAD-AMP will hang up to connect the two parties. If the phone number dialed by the RAD-AMP is busy, the unit will flash and beep twice for “busy”...