Magnavox 51MP392H Owner's Manual page 9

he TV's audio/video (AV) input jacks" provide
)r direct picture and sound connections
between the 7!/and accessory devices such as
VCRs, DVD players, and others that have AV out-
put jacks.
This" example, which uses' the INPUT-AV 1 jacks,
shows you one way you can connect a VCR to
your TK
Refer to the directions-for-use manual for your
VCR for further information on connections.
To make the connections shown in this example,
you will need:
• one coaxial _ztble (75_)
• one cable for a video connection (standard
RCA connector)
• two cables'for audio connections (standard
RCA connectors) (only one cable is"needed for
a nonstereo VCR).
NOTE: The cables are not supplied with your TK
You should be able to buy them at most stores
that sell electfoni_s'. Or you _ztn _ztll our
Customer Care Center at 1-800-531-0039
Connect a cable TV or antenna signal to
the ANT IN jack on the rear of the VCR.
Connect fl'om the OUT jack on the rear
of the VCR to the ANTENNA IN 75_
jack on the rear of the TV.
Connect the VIDEO OUT jack on the
rear of the VCR to the INPUT AVI
VIDEO jack on the rear of the TV.
Connect the audio output R(ight) and
L(efl) jacks on the rear of the VCR to the
INPUT-AV 1 AUDIO jacks on the rear of
the TV.
NOTE: If the VCR is a mono (nonstereo)
unit, connect only the left audio cable,
which usually has a white connector.
Press the AV button on the remote con-
trol as many times as necessary to select
the AVI source.
Turn the VCR on and press PLAY to
view a videotape on the TV.
Connecting Accessory Devices to Your TV
Rear of TV
Rear ofVCR _'
I
/ (Example: PhilipsVCR
model VR674CAT)
[]
©©© o
HELPFUL HINT
To simplify making connections, audio and
video cables often have color-code connec-
tors. The jacks on your TV are likewise
color coded to match the connectors. The
coding is as follows:
• Yellow for video (composite)
• Red for the right audio ch_mnel
• White for the left audio channel
NOTE: If your VCR is mono (non-
stereo), you will connect only one audio
cable. You nmst ensure that the TV is set
to MONO for the signal source to which
you've connected the VCR (INPUT-AV 1,
INPUT-AV2, or the side panel inputs
[AV3I). Otherwise, you will receive
sound from only one of the TV's speak-
ers. See page 27.