Advertisement
Programming the remotecontrol
to operateyourotherdevices
Your Toshiba monitor's
remote control is preprogrammed
to
operate
most Toshiba
devices.
To program
your monitor's
remote control to operate
a non-Toshiba
device (or a Toshiba
device that it is not preprogrammed
to operate),
follow the
steps below. For details on using the remote control to operate
the device, see page 18.
2
3
4
In the remote control code table (Ir_ _ page 21 ), find the
code for your device.
If more than one code is listed, try
each one separately
until you find one that works.
Set the MODE SELECT
Switch to the type of device you
are programming
the remote
control to operate --
CABLE/SAT
(for a cable converter
box or satellite
receiver),
DVD (for a DVD player or HTIB [home theater
in a boxl), or VCR dor a VCR or TV/VCR
combo).
RECALL
SS
While holding
down
© , pre.;s tile Channel
Number
buttons
to enter the 3-digit code for your device.
To test the code, turn on the device, point the remote
control at it. and
POWER
see notes
press
(-,_ . (Also
below.)
• If the correct
code was entered, the device will turn off.
• If the device does not respond,
repeat steps 1-4 using
another
code.
• If the device does not respond
to another code, you will
need to use the device's
original
remote control.
5
Remember
to set the MODE
SELECT
Switch back to
"TV" to control the monitor.
6
For future reference,
write down the code(s)
you used:
€
0
Note:
• In addition to POWER, confirm thatallnecessarykeys
on the
remote control operate your device, tf some keys are not
operational, repeat the device code setup using another
code (if other codes are listed for your device). If, after trying
all listed codes, the necessary keys do not operate your
device, use the device's original remote control
• Every time you change the batteries, you will need to
reprogram the remote control.
° Some newer VCRs respond to either of two codes. These
VCRs have a switch labeled "VCR1/VCR2." tf your VCR has
this kind of switch and does not respond to the codes for
your VCR brand, set the switch to the other position ("VCR 1"
or "VCR2") and reprogram the remote control.
2O
Advertisement
