Storage - Micrel Rhythmic evolution Instructions For Use Manual

2. Use one of the recommended disinfectant solutions listed in paragraph 11.2.2 to
spray on a clean, soft, lint-free cloth (microfiber). The cloth must be slightly damp
with the sprayed disinfectant.
3. Wipe the carrying bag using the damped cloth and repeat wiping for 5min.
4. Be careful not to clean the metal parts of the carrying bag.
5. Wipe the surface using a clean, soft, lint-free cloth damped with water.
6. Let air dry.
After removing protective equipment on completion of task, thoroughly wash and dry
hands. The disposable equipment must be discarded according to local regulations.
• The use of non reccomended cleaning solutions and disinfectants and the failure to
follow Micrel cleaning and disinfection procedure may result in product damage.
• To avoid equipment damage, cleaning solutions must be used according to the table
displayed in paragraph 11.2.2 and manufacturer reccommendations.
• Do not use hard or pointed objects to clean accessories.
• Do not spray directly cleaning fluids on the accessories.
• Do not steam autoclave, ethylene oxide sterilise or immerse accessories in any fluid.
• Do not use UV radiation to disinfect the accessories.
• Do not use compressed air to dry the accessories.
• Do not mix the disinfectant with any other product or chemical.
• Do not use solutions that contain: ammonia, amines, aldehyde, ammonium
compounds, alcohol, phenols, ethers, ketones, esters, aromatic H/C (benzene, xylene,
toluene, chlorobenzene, white spirit, paint thinner, e.t.c.), benzoic acid and benzoates,
chlorinated H/C solvents (trichlorethane, methylene chloride, chloroform, ethylene chloride,
e.t.c.), phosphoric acid in concentration above 10%, phosphates, acid solutions (citric acid,
sulphurous acid, acetic acid, hydrochloric acid) alkali bases (caustic potash, caustic soda,
ammonium hydroxide, e.t.c.), sodium hypocloride (bleach) solutions, ozone, acetylene,
loctite adhesives, varnish, gasoline, kerosene, naphtha, heptane, hexane, essential oils,
silicone fluid and iodine.

11.3 Storage

If the pump is to be stored for a long period of time (more than 3 months) it should
be cleaned. Store the pump according to storage condition described in Chapter
12, paragraph 12.6 "Envirommental Conditions" and if available, employ the original
packaging for protection.
88
!
Caution