Select Programming Units; Programming Procedure For Continuous+Bolus Mode - Micrel Rhythmic evolution Instructions For Use Manual

5.2.3 Select programming units

At the beginning of programming procedure, it is possible to select the programming
unit from ml, mg and μg.
When mg and μg programming units are used, entering the drug concentration is
required.
Press the soft key to select the programming unit from either the rate screen
UNITS
or the concentration screen.
BASAL RATE:
000.
UNITS
Use
The programming unit can't be changed over the course of an infusion.
The programming unit selected is stored and will be proposed for the next infusion.

5.2.4 Programming procedure for Continuous+Bolus mode

BASAL RATE:
000.
0
ml/hr
UNITS
BOLUS
05.
0
m1
LOCKOUT INTERNAL
015
min
38
0
ml/hr
SELECT MODE
PGM
CURRENT UNITS : (ml)
μg
mg
to select the desired programming unit.
Enter the BASAL RATE and press
You can change the programming units in this screen by using
the soft key, please refer to Chapter 5 paragraph 5.2.3
UNITS
"Select programming units".
If infusion was previously set in mg or μg, the drug concen-
tration will be asked first.
If this parameter is not required, the value 000.0 should be entered.
Note: If the basal rate value is higher than 49.9 ml/h then the
Bolus dose and Lockout interval functions are disabled and will
not appear on screen.
Enter the patient BOLUS
If this parameter is not required, the value 000.0 should be entered.
Note: If the patient Bolus parameter is set to 000.0 ml (or mg or
μg) then the Lockout interval, bolus limit or dose limit functions
are disabled and will not appear on screen.
Enter the LOCKOUT INTERNAL value in minutes and press
If this parameter is not required, the value 000 should be
entered.
CONCETRATION:
00.
0
mg/ml
UNITS
ml
.
and press
dose value
.
.