Table of Contents
Advertisement
Design and function
MIG/MAG welding
Please note!
•
The system is not designed for simultaneous welding.
•
Do not connect any further accessories to the 7-pole connection socket.
5.8.3.1
Switching between wire feed units
On the welding torch of the inactive wire feed
•
Tap torch trigger (press briefly)
Changeover is only carried out if no welding current is flowing!
5.8.3.2
Special points when operating with two wire feed units
Operation with two wire feed units allows you to weld different materials alternately with one welding
machine (e.g. welding steel and CrNi).
The machines can be equipped with different filler materials and the corresponding shielding gases.
The corresponding welding task is set at the respective machine control of the wire feed unit (see chapter
"Selecting MIG/MAG welding tasks").
During the start procedure, the controls of the wire feed unit will show the last active JOB for
about three seconds. The unit is then ready to weld.
The start procedure is carried out
•
at the control configured as master, after switching on
•
at the control configured as slave, after switching over for the first time
42
099-005459-EW501
17.12.2015
Advertisement
Table of Contents
Need help?
Do you have a question about the alpha Q Progress drive 4D EF and is the answer not in the manual?
Questions and answers