Beurer IH 57 Instructions For Use Manual page 47

• If the spray mist is flowing out of the device and the LED indicator
device is operating correctly.
NOTICE
The most effective way of nebulising is by using the mouthpiece. Nebulisation using a mask is only
recommended if it is not possible to use a mouthpiece (e.g. for children who are not yet able to inhale
using a mouthpiece). When using a mask to inhale, take care to ensure the mask fits well and the eyes
are unobstructed.
The device medication flow rate is set to "high" in the factory settings. You can adjust the medication
flow rate during use by pressing and holding the On/Off switch
flashes blue. You can switch from the high to the low nebulisation rate and back again. If the LED
5
indicator lights up continuously blue, this indicates a high nebulisation rate of ≥ 0.4 ml/min; if the LED
5
indicator flashes blue slowly, this indicates a low nebulisation rate of ≥ 0.2 ml/min.
5
Adjust the medication flow rate according to your requirements.
7.5 Inhaling correctly
Breathing technique
• It is important to use the correct breathing technique to ensure that the particles are distributed
as widely as possible throughout the airways. To ensure that the particles reach your airways and
lungs, you must breathe in slowly and deeply, then hold your breath briefly (5 to 10 seconds) and
then breathe out quickly.
• Nebulisers should only be used for the treatment of respiratory diseases after consultation with your
doctor. They will advise you about chooosing the medications suitable for inhalation therapy, and at
what dose and how to use them.
• Certain medications are only available with a prescription.
for 3 seconds until the LED indicator
4
47
is lit up continuously blue, the
5