Viking DVA-2WA Technical Practice page 6

P r o g r a m m
P r o g r a m m
A. Recording from an Electret Microphone or Carbon Handset
Step 1. Set DIP switch 1 to the OFF position and remove any background music source from the AUX AUDIO input.
Step 2. Connect the 1/8" Electret microphone plug to the Record Audio input and set DIP switch 7 to the OFF position or
connect a carbon handset to the modular jack of the DVA-2WA and set DIP switch 7 to the ON position.
Step 3. Slide the PLAY/RECORD switch to the right, the LED will light steady to indicate the DVA-2WA is in the record mode.
Note: To avoid feedback, turn the Master Volume control to "min" position.
Step 4. Momentarily press the START/STOP button to begin recording. The LED will flash fast to indicate you are recording.
Step 5. Momentarily press the START/STOP button again to stop recording, the LED will light steady.
Step 6. Repeat steps 4 and 5 for each message you wish to record.
Step 7. Slide the PLAY/RECORD switch to the left to place the DVA-2WA back into the play mode.
Step 8. Turn up the Master Volume control and review recording(s) by momentarily pressing the START/STOP button and
listening to messages in handset, speakers or 600 ohm output.
Note: If the total available record time is surpassed while recording, the status LED will pulse hi-low. To re-record all user-record-
ed messages, move the switch to play then back to the record position. This will allow you to record over all the previous messages
in memory.
* Note: If you experience hum dur-
ing the playback of user-recorded
messages, earth ground Speaker
Output terminal 5 and re-record
messages.
Carbon Handset Viking
part # Q171030 or
equivalent (not included),
set DIP switch 7 to ON
B. Recording from a Tape, CD Player or Any Line Level Source
Step 1. Place DIP switch 1 in the OFF position and DIP switch 7 in the ON position and disconnect any background music
source from the Aux Audio input.
Step 2. Set the volume on the tape/CD player to a middle setting.
Step 3. Connect the output from the Tape/CD player to the RECORD AUDIO input jack of the DVA-2WA using the double ended
1/8" audio cord provided.
Step 4. Slide the Play/Rec switch to the right, the LED will light steady to indicate the DVA-2WA is in the record mode.
Step 5. Start the tape/CD player and monitor when to start/stop the recording by listening through the speaker(s) connected to
terminals 5 and 6 or monitor with handset connected to the handset REC/MONITOR jack (mouthpiece is disabled).
Step 6. Momentarily press the START/STOP button to begin recording. The LED will flash fast.
Step 7. Momentarily press the START/STOP button again to stop recording. The LED will light steady.
Step 8. Repeat steps 5 through 7 for each message you wish to record.
Step 9. Slide the PLAY/REC switch to the left position to place the DVA-2WA back into the play mode.
120V AC
* Note: If you experience
hum during the playback of
user-recorded messages,
earth ground Speaker
Output terminal 5 and re-
record messages.
Optional handset for
monitoring recordings.
Viking part # Q171030 or
equivalent (not included)
i n g a n d R
i n g a n d R
120V AC
VIKING VIKING
1
OFF
VIKING VIKING
MASTER
VOLUME
MIN MAX
WITH 2 WATT AMPLIFIER
1
OFF
Double ended 1/8"
audio cord included
e c o r d i n g
e c o r d i n g
MODEL DVA-2WA
©
MASTER AUX. AUDIO
VOLUME VOLUME
VIKING
ELECTRONICS
HUDSON, WI 54016
MIN MAX MIN MAX
DIGITAL ANNOUNCER
WITH 2 WATT AMPLIFIER
S3 2
1 2 3 4 ON 5 6 7 1 3 4 5
1 2 3 4 5 6 7
C
REC
Play/Rec Switch
or
MODEL DVA-2WA
©
AUX. AUDIO
VOLUME
VIKING
ELECTRONICS
HUDSON, WI 54016
MIN MAX
DIGITAL ANNOUNCER
1 2 3 4 S3 5 6 7 1 2 3 4 5 6
ON
1 2 3 4 5 6 7
C
REC
Play/Rec Switch
Tape Player
(not included)
-or-
7
DIP switch 7 ON for
ON
Carbon Handset
DIP switch 7 OFF for
OFF
Electret Mic
6
* Earth
Ground
(PC sound card, etc)
Notes: If the total available record time is
surpassed while recording, the status LED
will pulse hi-low.
7
recorded messages, move the switch to
ON
play then back to the record position. This
will allow you to record over all the previous
messages in memory.
* Earth
Ground
CD Player
(not included)
Electret Microphone with
1/8" jack, Schriber Acoustic
Part # SA-125, Ph: 541-479-
9433 or equivalent
(not included),
set DIP switch 7 to OFF
To re-record all user-
PC Sound Card
(not included)