Operation - GRE VCB15 Instruction Manual

(2) No need to insert the suction head onto the
electric cleaner when suction the stones and
other large garbage and so on, as the Picture
B shows.
Brushes on the Suction Head can be removed
by pulling out directly from the head.
For Vinyl, liner and fibreglass pools, it is recommended to keep the brushes on
the suction head to prevent damage to your pool.
Cleaning the cleaner after using the electric cleaner:
(1) Take the transparent body off the electric cleaner (following the OPEN-
CLOSE direction, rotate to OPEN direction
90 degrees), and take the garbage out of the
transparent body, and then clean it.)
(2) Take out the rear part of filter bag, and
take out the filter bag, and get out the
garbage, and then clean the filter bag.
The cleaning steps of filter bag
1. Pull out the basket and filter bag from the rear of pool cleaner;
2. Detach the filter bag from the filter basket;
3. Clean the filter bag and filter basket
(3) Check whether there is garbage on the impeller. lf it has, take out the
garbage, and clean the impeller.

OPERATION

Warning
Do not use the cleaner if any damage is found.
Pollution of the liquid could occur due to leakage of lubricants.
Do not operate this cleaner when people/pets are in the water.
Make sure the cleaner is fully immersed in the water befare operating. DO
NOT operate it outside of water. lt will lead to failure of the shaft seals/motor,
and then VOID the warranty.
Maximum water temperature: 4 ºC (39.2 ºF)-35 ºC (95 ºF) DO NOT use the
cleaner without intact filter sock and sleeve in place. Using you cleaner
without intact filter sock and sleeve in place will VOID your warranty.
5