How It Works - Viking C-1000B Integration Manual

Monitor Who is at Your Door/Gate on Your
Unused Line/
Trunk Input on
Phone System
(PABX/KSU)
Camera
Power
Composite
Video Out
*Axis
Communications
Model 247S
Video Server
Video In
(BNC Connector)
Network
(PoE)
* For more information on Axis Communications products, visit: www.axis.com
Receptionist's Computer Monitor
Viking Model C-2000A
Door Entry Controller
DOD # 156
Doorstrike/
Magnetic Lock
Viking Model K-1705-3
Video Entry Phone with Keypad
(shown in optional VE-6x7)
DOD # 159
RG59 or
RG6 Cable
PoE Switch
Facilitate the installation by
powering the video server via a
Power over Ethernet-enabled
switch. Optionally secure the
system with a Uninterruptible
Power Supply (UPS).

How it Works:

The receptionist can simply answer the call from the
entrance, check their computer monitor to verify
identity then enter a touch tone command on the phone
to activate the doorstrike or gate.
C-2000A Programming Steps Required when Connecting
to a Phone System's Unused Line Input:
Step 1. Connect the power, required entry phones and doorstrike
outputs (if required).
Step 2. Connect the unused phone system (PABX/KSU line/trunk
port to terminals 4 & 5, "LINE OUT TO PHONES" on the
C-2000A.
Step 3. Access programming. Enter *5, two beeps should be heard.
Step 4. Enter additional desired programming, then hang-up the
phone and place DIP switch 2 back to the OFF position.
This video application also applies
to these Viking video phones:
Model
E-35
E-50
INTERNET
DOD#
178
191
Receptionist PC
with video management
software (included with
Axis 247S). Monitor,
record and play back
video.
PC
Monitor the
K-1705-3
camera remotely
over the WAN or
Internet network.
1-8-08