Philips 55PP9401 Service Manual page 53

Note: When the remote control transmitter is in DCAM, the TV button will not illuminate.
Note: The remote control transmitter will time out of DCAM in approximately 20 seconds.
4. Press the Help key on the remote control transmitter. A green crosshatch will appear.
5. Press the Exit key (this is the Phase Adjustment Mode).
6. Adjust the data value using the keys specified in the chart below so that the data value
corresponds to the chart value.
Saving Data Values
7. Press the Help key to exit Phase Mode.
8. Press the PIP (-) key twice to store the information.
9. When green dots are displayed, press the Mute key.
Adjustment Procedure (1080i HD Mode)
10. Change to 1080i HD Mode. Press the Exit key five times to exit to video mode.
11. Change the remote control transmitter to TV mode by removing and replacing a battery.
12. Input a 1080i signal, select that input, bring up the Customer Menu, select Format, and select
1080i HD mode.
13. Press Exit to leave the Customer Menu.
14. Press the Service Only switch to return to the DCU grid..
15. Place the remote control transmitter into the DCA Mode by removing a battery, pressing and
holding the 7 and 9 keys, and replacing the battery.
16. Repeat steps 4 through 9 above, using the appropriate data values from the chart below for
1080i Mode.
17. Press the Service Only switch to return to Normal Video Mode.
Data Value Chart
Phase Mode
Adjust Using
4 and 6 keys
on remote control
2 and 5 keys
on remote control
cursor left and right
on remote control
cursor up and down
on remote control
Display Format
Normal
Address Data Value
PH-H BF
PH-V 07
CR-H 4C
CR-V 0C
7618 Service Adjustments page 22
Display Format
1080i HD
Address Data Value
PH-H BF
PH-V 07
CR-H 4C
CR-V 0C