Viking C-1000B Technical Practice page 6

D. Wiring the W-3005 Camera
1. Using RG59 for Video and CAT5 for Camera Power and Phone Board Audio (Recommended)
Back View of the W-3005
* Warning: The doorbox power run wire length is limited to 125 ft of 24 AWG wire. Longer power runs will require heavier gauge wire (doubling pairs)
and/or a higher voltage power adapter. Power runs from 125 - 250 ft of 24 AWG wire are possible using a Radio Shack 18VAC adapter (part # 273-
1690). Voltage at the doorbox power input connections must not exceed 18VAC RMS.
** Note: The maximum camera power supply wire run length is 500 ft of 24 gauge wire (CAT 5/6), longer runs are possible by doubling pairs or increasing the wire gauge.
*** Note: RG59 or RG6 with solid center conductor and 95% bare copper braid shield.
2. Using CAT5E or CAT6 for Video, Camera Power and Phone Board Audio (see Caution below)
Back View of the W-3005
* Note: Up to 150 ft video cable run length can be achieved using CAT5E or CAT6 cable. Longer cable runs can be used if a passive or active video Balun transceiver is used on
each end of the cable. Generally, passive transceivers can achieve up to 750 ft cable runs where active transceivers can achieve up to 3000 ft runs depending on cable type, etc.
The type of video balun transceiver required is specific to your cable run length. For more information on video balun transceivers go to: www.northernvideo.com.
** Note: The maximum camera power supply wire run length is 500 ft of 24 gauge wire (CAT 5/6), longer runs are possible by doubling pairs or increasing the wire gauge.
*** Note: RG59 or RG6 with solid center conductor and 95% bare copper braid shield.
*** Warning: The doorbox power run wire length is limited to 125 ft of 24 AWG wire. Longer power runs will require heavier gauge wire (doubling
pairs) and/or a higher voltage power adapter. Power runs from 125 - 250 ft of 24 AWG wire are possible using a Radio Shack 18VAC adapter (part
# 273-1690). Voltage at the doorbox power input connections must not exceed 18VAC RMS.
Caution: When routing CAT5E or CAT6 cable, maintain a minimum distance of 3 ft from any parallel high voltage wire (110 VAC) and a minimum of 2 ft from crossing any high volt-
age wire. For installations where RF noise is expected (commercial applications) or wire runs are near high voltage (110 VAC) wires, a shielded video cable such as RG6 is recom-
mended.
6
3-Wire Gel-Filled Butt Connectors
included (3M Scotchlok UR2)
Center conductor
stripped back 5/8"
Yellow (Video)
Twisted foil and
braided shield
- Black (GND) ** Camera GND (-)
+ Red (6VDC) ** Camera Pwr (+)
* Doorbox Power
W/G
* Doorbox Power
G/W
Doorbox Board Audio In/Out (Tip)
Doorbox Board Audio In/Out (Ring)
3-Wire Gel-Filled Butt
Connectors included
(3M Scotchlok UR2)
Video Out (+)
Video GND (-)
** Camera GND (-)
** Camera Pwr (+)
* Doorbox Power
W/G
* Doorbox Power
G/W
Doorbox Board Audio In/Out (Tip)
W/BL
Doorbox Board Audio In/Out (Ring)
*** RG59 or RG6
Shielded
Video Cable
Up to 1000 ft
CAT5 Cable
W/O
O/W
* Up to 250 ft
W/BL
See page 4, section B
Wiring the W-3005 Board
BL/W
* CAT5E or
W/BN
CAT6 Cable
(see Caution below)
BN/W
W/O
O/W
**** Up to 125 ft
See page 4, section B
Wiring the Doorbox
BL/W
"F" to Phono Plug
"F"
Adapter
(Radio
To unused input on TV, VHF
Connector
Shack part #278-252)
modulator, whole house
video distribution equip-
ment, video server, etc.
6V DC Adapter (included)
Crimp-on Splice
Connectors (not included)
Black
Camera GND (-)
W/O
O/W
Camera Power (+)
13.8V AC Adapter
W/G
* Doorbox Power
G/W
(not polarity
BL/W
sensitive)
W/BL
To unused input on TV, VHF modulator,
whole house video distribution
equipment, video server, etc.
Video Out (+)
Video GND (-)
Crimp-on Splice
6V DC Adapter
W/BN BN/W
Connectors
(not included)
Black
Camera GND (-)
W/O
O/W
Camera Power (+)
13.8V AC Adapter
W/G
**** Doorbox Power
(not polarity
G/W
BL/W sensitive)
W/BL
!
120V AC
(-)
( + )
Black with
White Stripe
(included)
!
120V AC
(-)
(+)
Phono (RCA) Plug,
F Connector, Etc.
(included)
!
120V AC
(-)
( + )
Black with
White Stripe
(included)
!
120V AC