Viking C-1000B Technical Practice page 3

C. Wiring the W-1000 and W-1000-EWP
Important: Do NOT install a W-1000 or W-2000A on a
telephone line without a C-1000B Controller (Fax Back
Document 155).
C-1000B Controller
VIKING
MODEL C-1000B
©
ELECTRONICS
HUDSON, WI 54016
DOOR ENTRY / CCTV VIDEO
/ PAGING CONTROLLER
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19
COM N.O. N.C. - - - - AUX.
CONTACT
OUTPUT
SIG GND SIG GND SIG GND ON
VIDEO 1 IN VIDEO 2 IN VIDEO OUT
C C 1 2 3 C
TALK BATTERY
LED1 LED2 LED3
OFF ON
EARTH C.O. LINE OUT TO KEYLESS DOOR DOORBOX DOOR N.O. COM N.C. N.O. COM N.C.
GND INPUT PHONES C.C. INPUT BOX 1 13VAC PWR BOX 2 DOOR STRIKE 1 DOOR STRIKE 2
C.O.
Line
D. Wiring the W-2000A and W-2000A-EWP
Important: Do NOT install a W-1000 or W-2000A on a
telephone line without a C-1000B Controller (Fax Back
Document 155).
C-1000B Controller
VIKING
MODEL C-1000B
©
ELECTRONICS
HUDSON, WI 54016
DOOR ENTRY / CCTV VIDEO
/ PAGING CONTROLLER
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19
COM N.O. N.C. - - - - AUX.
CONTACT
OUTPUT
ON
SIG GND SIG GND SIG GND
VIDEO 1 IN VIDEO 2 IN VIDEO OUT
1 2 3
C C C
TALK BATTERY
LED1 LED2 LED3
OFF ON
EARTH C.O. LINE OUT TO KEYLESS DOOR DOORBOX DOOR N.O. COM N.C. N.O. COM N.C.
GND INPUT PHONES C.C. INPUT BOX 1 13VAC PWR BOX 2 DOOR STRIKE 1 DOOR STRIKE 2
C.O.
Line
* Note: The gel-filled (water-tight) butt connectors are designed for insulation displacement on 19-26 gauge wire with a maximum insulation diam-
eter of 0.082 inches. Cut off stripped wire ends prior to terminating.
** Note: To increase surge protection, loosen the PCB mounting screw labeled
ed) from the mounting screw to Earth Ground (grounding rod, water pipe, etc.)
*** Warning: The power run wire length is limited to 150 ft of 24 AWG wire. Longer power runs will require heavier gauge wire (doubling pairs)
and/or a higher voltage power adapter. Power runs from 150 - 250 ft of 24 AWG wire are possible using a Radio Shack 18VAC adapter (part # 273-
1690). Voltage at the doorbox power input connections must not exceed 18VAC RMS.
**** Note: When wires are routed from above, a "drip loop" is recommended to keep water away from the circuit board.
P r o g r a m m
P r o g r a m m
Rear View of the
W-1000/W-1000-EWP/
W-2000A/W-2000A-EWP
DIP
Switches
OFF ON
Unused
PABX/KSU
Single Line
Trunk Input
Phone
or
IMPORTANT: Electronic devices are susceptible to lightning and power station electrical surges from both
Multi-Line
!
the AC outlet and the telephone line. It is recommended that a surge protector be installed to protect
Phone
against such surges. Contact Panamax at (800) 472-5555 or Electronic Specialists Inc. at (800) 225-4876.
Unused
PABX/KSU
Single Line
Trunk Input
Phone
* Gel-filled butt
or
Multi-Line
IMPORTANT: Electronic devices are susceptible to lightning and power station electrical surges from both
!
Phone
the AC outlet and the telephone line. It is recommended that a surge protector be installed to protect
against such surges. Contact Panamax at (800) 472-5555 or Electronic Specialists Inc. at (800) 225-4876.
i n g
i n g
Rear View of the W-1000/W-1000-EWP
(Spade connector
included)
** Earth
Ground
(optional)
* Gel-filled butt
connectors
(EWP only)
Line
Output
Red
**** Drip Loop
Green
(optional)
Rear View of the W-2000A/W-2000A-EWP
connectors
(EWP only)
***
Line
Output
Red
**** Drip Loop
Green
(optional)
(as shown above) and fasten a wire with spade terminal (includ-
W-1000/W-2000A
W-1000/W-2000A
Note: Pots are shown in factory default settings.
Gel-filled butt
connectors
***
13.8V AC (EWP only)
Power Input
(18V AC max)
(Spade connector
included)
** Earth
Ground
(optional)
Gel-filled butt
connectors
13.8V AC
(EWP only)
Power Input
(18V AC max)
Microphone Volume
(see section A)
Speaker Volume
(see section B)
120V AC
120V AC