Dometic FreshJet 3 Series Installation And Operation Manual page 15

Rooftop Air Conditioner (Air Distribution Box, Electronic Controls)
e
q
13 Confirming the foam divider height measurement
Flat surface of the
q
ADB
Stack of foam
w
dividers
5. Place the ADB face down on a stable, protected, flat
surface.
6. Stack the foam dividers required and place them onto
the ADB.
7. Measure the full height, from the flat surface of the
ADB to the top of the foam dividers to confirm the
full height is equal to the previously determined roof
thickness.
8. Adjust the number of foam dividers to reach the
correct full height, as necessary.
EN
w w
Full height
e
measurement (equal to
the roof thickness)
r r
e e
q q
14 Passing the wire through the filter notch
Filter
q
Filter notch
w
9. Slide out the filter to expose the filter notch.
10. Pass the 4-pin communication cable and the 2-pin
lighting cable (if equipped) through the filter notch.
Installation
w w
4-Conductor
e
communication cable
2-Conductor light cable
r
15