Cleaning; Common Configuration Questions; General Questions; What Do The Leds On The Front Panel Mean - National Instruments PXIe-8880 Getting Started

Hide thumbs Also See for PXIe-8880:

Table of Contents

1. Power off the chassis.

2. Remove any cables that may be attached to the controller front panel.

3. Unscrew the four bracket-retaining screws in the front panel.

4. Press the injector/ejector handle down.

5. Slide the unit out of the chassis.

Cleaning

Use a dry, low-velocity stream of air to clean the NI PXIe-8880 controller. If needed,

use a soft, nonmetallic brush for cleaning around components.

Make sure that the device is completely dry and free from contaminants before

returning it to service.

This section answers common configuration questions you may have when using a

NI PXIe-8880 embedded controller.

Refer to the LED status descriptions in the Front Panel Features section.

Related reference:

Front Panel Features

■

After shutting down my NI PXIe-8880 controller, the Port 1 Ethernet LEDs

continue to blink. Is it safe to remove my controller or disconnect power?

The NI PXIe-8880 port 1 Intel I217 Ethernet device remains powered even after

shutdown. It is safe to remove your controller or disconnect power.

How do I check the configuration of the memory, hard drive, time/date, and

so on?

You can view these parameters in the BIOS setup. Complete the following steps to

enter the BIOS setup:

PXIe-8880 Getting Started

Table of Contents