Table of Contents
Advertisement
ATTACH SIDE ARM ASSY
STEP 5
1. Remove the single bolt attached to the Side
Hinge (F)(Figure 6.1) on the side of the spa.
Attach the Side Arm Assembly (E) (Figure
6.1) to the Side Hinge (F) (Figure 6.1) using
the single bolt. Repeat on other side of spa.
2. IMPORTANT: Plastic Bottom (Pivot Bracket) of
Side Arm Assembly (E) must lay fl at against spa
siding.
DO NOT OVERTIGHTEN SCREW or the cover
F
E
STEP 6
ALIGN SIDE ARM ASSY.
46˚
H
7
PROLIFT III INSTALLATION
will bind.
E
Figure 6.1
Figure 7.1
1. Locate the Cardboard Template (H) and place
on ground below Side Arm Assembly (Figure
7.1).
2. Slide Template against Side Arm Assembly,
making sure the entire angle of the Template
touches the Side Arm Assembly (Figure 7.1).
3. Position the Plastic Bottom (Pivot Bracket)
with the holes facing away from the back of
the cover (Figure 7.2).
If Pivot Bracket rests on both the side panel
and corner panel, creating a gap behind the
Pivot Bracket, Pivot Bracket may be rotated
180° and placed onto the corner panel of spas.
4. Holding Pivot Bracket in place, mark all 4
holes and pre-drill with 1/8"(3mm) drill bit at a
depth of 1/2"(12.5mm) into spa cabinet.
Use the appropriate size screws to secure the
Side Arm Assembly. Please use (Figure 7.2)
and information on Page 8 of this document to
determine the correct screw size.
Advertisement
Table of Contents
