Prolift Iii Installation; Attach Back Hinges; Attach Side Hinges; Assemble Crosslink - Watkins Wellness ProLift III Installation Manual

STEP 1

ATTACH BACK HINGES

1. Locate Bag #1, some of the contents will be
used to fasten the Rear Hinges.
REAR HINGES:
2. Line up the top Rear Hinge(G) holes (Figure
2.1) with 2 of the marked holes on the back
side of the cover. Using the cordless drill and
square drive bit fasten the Rear Hinge(G) to
the cover by using two of the #10 x 1"square
(I) Flat Head screws on the top (marked)
holes fi rst. Using the 1/8" drill bit and the
bottom two holes of the Rear Hinge(G), drill
through the hidden aluminum plate followed
by inserting two more of the same screws
in the bottom holes. Repeat procedure for
second Rear Hinge.

ATTACH SIDE HINGES

STEP 2
1. Locate Bag #1, some of the contents will be
used to fasten the Side Hinges.
SIDE HINGES:
2. Line up the top Side Hinge(F) holes (Figure
2.2) with 2 of the marked holes on one side
of the cover.
3. Using the cordless drill and square drive bit
fasten the Side Hinge to the cover by using

PROLIFT III INSTALLATION

G
I 4x
Figure 2.1
two of the #10 x 1½"square (J) Flat Head
screws on the top (marked) holes fi rst.
4. Using the 1/8" drill bit and the bottom two
holes of the Side Hinge, drill through the
hidden aluminum plate followed by inserting
two more of the same screws in the bottom
holes. Repeat procedure for Side Hinge on
opposite side of the cover.
Repeat procedure for Side Hinge on
opposite side of the cover.
F
J 4x
STEP 3

ASSEMBLE CROSSLINK

1. Locate the Right & Left Pivot Assemblies,
Crosslink and (4) ¼"-20 Hex Bolts (Figure 4.1).
B
2. Orient (Figure 4.1) on fl oor and attach A and
B to C using (4) ¼"-20 Hex Bolts (M).
Figure 3.1
C
A
Figure 4.1
M
4x
4