Table of Contents
Advertisement
PIVOT BRACKET SPACER INSTALLATION
ALIGN SIDE ARM ASSY.
STEP 1
1. Locate the Template with 46° printed on it and
place on ground below Side Arm Assembly
(Figure 4.1).
2. Slide Template against Side Arm Assembly
making sure the entire angle of the Template
touches the Side Arm Assembly (Figure 4.1)
STEP 2
DRILL HOLES INTO SPA
1. Position W or X Side Spacer against Pivot
Bracket E, and insert two screws (L) from the
back. Then position arm so rib of side spacer
fi ts into appropriate groove. Predrill 7/64"
holes into the spa (Figure 5.1) with 1" max.
depth. There are (4) holes per Pivot Bracket.
2. Position the Plastic Bottom (Pivot Bracket)
(E) with the holes facing toward the middle
of the spa (Figure 5.1).
13
O
46
Figure 4.1
E
STEP 3
SECURE PIVOT BRACKETS & SPACERS TO SPA
1. Remove the two screws (L) from the back of
W or X. Making sure that the holes on Spacer
(W) align with Bracket (E), secure bracket and
Spacer (W) to spa using 4 Flat head Screws
(L) (Figure 6.1). Bag # 3 (L) (#10 2" Flat Head
screws).
L
E
Important: Make sure that the Spacer (W)
back end fi ts into the vertical groove between
the corner and side panel.(Figure 6.2)
Figure 5.1
W
Figure 6.1
Advertisement
Table of Contents
