Table of Contents
Advertisement
STEP 4 ATTACH CROSSLINK ASSY.
1. Unscrew Pan Head Screws attached to the
Rear Hinges (G) (Figure 5.1).
2. Align both Pivot Assemblies (attached to
the Crosslink assembly) inside the Rear
Hinges and fasten using the two Pan
Head Screws (Figure 5.1).
3. Rotate Pivot Assemblies until the bottom
(Mounting Bracket) touches the side of
the spa (Figure 5.2).
For the following steps on Utopia
Spas (2016-Current), please go to
page 10 at the end of this document.
5
PROLIFT II INSTALLATION
G
Figure 5.1
Figure 5.2
IMPORTANT: Carefully examine cover to be
sure it is still aligned evenly with the outside
edges of the spa bar top (Figure 1.3).
4. Using the Mounting Bracket (bottom part
of the Pivot Assembly) as a template,
predrill 1/8"(3mm) holes into the back of
the spa (Figure 4.3) with ½"(12.5mm) max.
depth. There are (7) holes per Mounting
Bracket (Figure 5.3).
Use the appropriate size screws to secure the
Mounting Brackets. Please use (Figure 5.4)
and information on Page 6 of this document to
determine the correct screw size.
®
Figure 5.3
Advertisement
Table of Contents
