Watkins Wellness ProLift II Installation Manual page 13

PIVOT BRACKET SPACER INSTALLATION
ALIGN SIDE ARM ASSY.
STEP 1
1. Locate the Template (H) and place on
ground below Side Arm Assembly (Figure
4.1).
2. Slide Template against Side Arm Assem-
bly making sure the entire angle of the
Template touches the Side Arm Assembly
(Figure 4.1)
DRILL HOLES INTO SPA
STEP 2
1. Position T1 or S1 Side Spacer against Pivot
Bracket E, and insert two screws (L) from the
back. Then position arm so rib of side spacer
fi ts into appropriate groove, predrill 7/64" holes
into the spa (Figure 5.1) with 1" max. depth.
There are (4) holes per Pivot Bracket.
2. Position the Plastic Bottom (Pivot Bracket) (E)
with the holes facing toward the middle of the
spa (Figure 5.1).
E
54˚
H
Figure 4.1
Figure 5.1
STEP 3
SECURE PIVOT BRACKETS & SPACERS TO SPA
1. Remove the two screws (L) from the back
of T1 or S1. Making sure that the holes on
Spacer (T1) align with Bracket (E), secure
bracket and Spacer (T1) to spa using 4 Flat
head Screws (L) (Figure 6.1). Bag # 3 (L)
(#10 2" Flat Head screws).
L
X4
E
T1
Important: Make sure that the Spacer (T1)
back end fi ts into the vertical groove on side
panel as shown(Figure 6.2).
Figure 6.1
Figure 6.2
12