Prolift Ii Installation; Attach Back Hinges; Attach Side Hinges; Assemble Crosslink - Watkins Wellness ProLift II Installation Manual

STEP 1

ATTACH BACK HINGES

1. Locate Bag #1. Some of the contents will be
used to fasten the Rear Hinges.
REAR HINGES:
2. Line up the top Rear Hinge (G) holes (Figure
2.1) with two of the marked holes on the
back side of the cover. Using the cordless
drill and square drive bit to fasten the Rear
Hinge to the cover by using two of the #10
x 1"square (I) Flat Head screws on the top
(marked) holes fi rst. Using the 1/8"(3mm)
drill bit and the bottom two holes of the Rear
Hinge, drill through the hidden aluminum
plate followed by inserting two more of the
same screws in the bottom holes. Repeat
procedure for second Rear Hinge.
STEP 2

ATTACH SIDE HINGES

1. Locate Bag #1. Some of the contents will be
used to fasten the Side Hinges.
SIDE HINGES:
2. Line up the top Side Hinge (F) holes (Figure
3.1) with two of the marked holes on one
side of the cover.
3. Using the cordless drill and square drive bit,
fasten the Side Hinge to the cover by using

PROLIFT II INSTALLATION

G
I 4x
Figure 2.1
two of the #10 x 1½"square (J) Flat Head
screws on the top (marked) holes fi rst.
4. Using the 1/8"(3mm) drill bit and the bottom
two holes of the Side Hinge, drill through the
hidden aluminum plate followed by inserting
two more of the same screws in the bottom
holes (Figure 3.1).
Repeat procedure for Side Hinge on
opposite side of the cover.
F
J 4x
STEP 3

ASSEMBLE CROSSLINK

1. Locate the Right & Left Pivot Assemblies,
Crosslink, and (4) ¼"-20 Hex Bolts (Figure
4.1).
B
2. Orient (Figure 4.1) on fl oor and attach (A and
B to C using (4) ¼"-20 Hex Bolts (M).
Figure 3.1
C
A
Figure 4.1
M
4x
4