Table of Contents
Advertisement
STEP 7
INSTALL GAS SPRING
1. Locate the Gas Spring (C) and snap onto the
upper ball stud (attached to the Pivot Arm
Assembly) with the barrel end of the Gas
Spring up (Figure 8.1).
2. Fold cover in half and pull to position shown
(Figure 8.2). Snap the lower joint of the Gas
Spring onto the lower ball stud (Figure 8.2).
9
PROLIFT II INSTALLATION
C
Figure 8.1
PROPER TECHNIQUE FOR OPENING AND
CLOSING COVER
3. Push on either side of cover to open or push
on either side of cover to close (Figure 8.3).
Cover should come to a gentle rest with a
slight tilt towards the spa.
Push
this
side to
Close
Always "ease" the cover to the Open
and Close Position to avoid "Slamming"
thereby prolonging the service life of
your cover.
Figure 8.2
Push this side to Open
Figure 8.3
Advertisement
Table of Contents
