Table of Contents
Advertisement
THE ADVANCED SWITCHING SYSTEM
3. Connect your amp(s). PLEASE NOTE, if you are only using one amplifier/DAW you MUST use OUT1 as this is
your earth/ground. Connect to your second amplifier or channel/DAW using OUT2, as this is isolated and
phase reversible.
4. Connect your tuner to the TUNER/AUX Output.
5. Connect any MIDI enabled pedals using the MIDI INPUT/OUTPUT.
6. Connect your Remote Switch controllable devices (i.e. Amp channel, Remote Loopy 2, Tap Tempo) using G3
ATOM's REMOTE SWITCH sockets.
7. Connect your power to G3 ATOM. We strongly recommend using TheGigRig Generator, supplied with your
G3 ATOM.
PROGRAMMING
1. Choose the preset that you wish to programme by pressing a PRESET FOOTSWITCH. It will light up and the
corresponding number will also appear on the LCD screen.
2. Select the EFFECTS LOOPS and CONTROL FUNCTIONS you wish to use with that preset.
3. Repeat for the other presets you wish to programme.
4. There is no store button. The G3 Atom remembers every time you press a button and automatically saves
after each step.
STOMPBOX MODE
This enables you to add any LOOP or combination of LOOPS and CONTROL FUNCTIONS on top of any standard
preset. This enables you to create and build sounds on the fly without being tied to traditional presets.
1. Choose the PRESET you want to turn into a STOMPBOX Mode preset, ie: using PRESET 7.
2. Select the LOOP(s) you want to turn on. In this example I want to add a delay that is in LOOP 6
3. Now make sure everything else is turned off, including OUTPUTS and PHASE OUT2.
4. Now press the STOMPBOX MODE button. A yellow LED will turn on next to the main preset LED.
5. Preset 7 is now in STOMPBOX Mode and will add the delay in LOOP 6, ON TOP of any other
preset.
You can add as many STOMPBOX MODE presets as you like. All Stompbox Mode presets will clear
when you press any normal preset. This can, however, be changed in the DEEP EDIT MENU, by
selecting either Sticky Stomp or Flash.
th
November 13
, 2023
7
Advertisement
Table of Contents
