■ Wiring cable size must comply with the applicable local and national codes. And "Electric characteristics" should be considered for electrical work and design.

Especially the power cable and circuit breaker should be selected in accordance with that.

■ Power factor could vary less than ±1% according to the operating conditions.

■ Sound level values are depend on the ambient conditions and values are normally higher in actual operation.

■ This product contains Fluorinated greenhouse gases.

■ Voltage supplied to the unit terminals should be within the minimum and maximum range.

■ Maximum allowable voltage unbalance between phase is 2%.

■ MSC means the Max. current during the starting of compressor.

■ MSC and RLA are measured as the compressor only test condition.

■ OFM and IFM are measured as the outdoor unit test condition.

■ Select the wire size based on MCA.

■ MFA is used to select the circuit breaker and ground fault circuit interrupter, and all installation site must require attachment of an earth leakage breaker.

[circuit breaker type is ELCB(Earth Leakage Circuit Breaker)].

■ Performances are based on the following conditions :

- Cooling : Indoor Ambient Temp. 27°CDB / 19°CWB, Outdoor Ambient Temp. 35°CDB / 24°CWB

- Heating : Indoor Ambient Temp. 20°CDB / 15°CWB, Outdoor Ambient Temp. 7°CDB / 6°CWB

- Interconnected Pipe Length is standard length and difference of Elevation (Outdoor ~ Indoor Unit) is 0m.