Echo shindaiwa PB-8010 Service Manual page 22

20
PB-8010, EB810
IGNITION SYSTEM
3-6 Replacing ignition switch (continued)
10. Connect throttle cable to carburetor (Refer to
"4-14 Checking and adjusting throttle cable").
11. Connect primary wire (A) and (P)
12. Connect ground wire (B) and (Q).
P
A
Q
B
13. Bind primary wire terminal (a1), ground wire
terminal (b1) and control cable (R) with clip (S).
R
14.Secure the clip (S) to fan case with bolt.
a1
b1
S
S
15. Put primary wire (A) into ribs of intake insulator
A
as shown.
NOTE: Make sure not to contact primary wire (A)
and debris guard (T).
T
16. Route control cable assembly (G) as shown.
17. Put control cable assembly (G) into groove on
engine cover as shown.
G
G
18. Reassemble all removed parts.