Table of Contents
Advertisement
Preparing your installation
Installation - In-Ceiling speaker
Before you unpack your speakers, please make sure that there is plenty of available floor space.
Inside the carton, you will find a cut-out template that you can use the mark and cut into your
ceilings or walls to the correct size, you'll also find your Quik-Link terminal and grille in the box.
Draw around cut-out template
Cut around traced lines
CAUTION: The Creator Series loudspeakers can only be fixed into plasterboard (dry-lined) or
suspended ceilings (in-ceiling models), with a thickness of up to 35mm (excluding the Super
Slim series, which can be fixed up to 15mm) and walls (in-wall models), with a thickness of up
to 30mm. Solid wall installation will require channelling out and framework constructed to
provide a structure for the Tri Grip dog legs to clamp to. For safety reasons, if you are unsure
of your ability to provide a secure and safe fixing, do not attempt to fix these speakers,
please obtain the services of a competent and qualified trades person.
CAUTION: Ensure that there are no water pipes or electricity cables running within the wall
or ceiling structure before cutting the speaker apertures. Work from secure steps and avoid
Feed speaker wire to hole
Insert speaker wire into Quik-Link
trailing wires.
Overtightening warning
Do not over tighten the Tri-Grip Dog Leg clamps. Over tightening the clamping mechanism on
any in ceiling/ in wall speaker can result in damage to the speaker mounting hardware, ceiling/
wall or speaker frame, and/or deflection in the speaker frame during installation.
Attach Quik-Link to terminal panel
Push speaker into hole and tighten
all 3 Tri-Grip dog legs
If you notice any of the above during installation, you have over tightened the Tri Grip Dog Leg.
Back off the mounting screw until deflection is reduced to allow the product to sit firmly against
the ceiling or wall.
IMPORTANT: Do not exceed 5Kgf/cm (4.34 lbf/inch.) or 0.5 NM when tightening
the Tri Grip dog leg screws.
When using a cordless screwdriver/ drill to install this product ensure the clutch is set to it's
lowest setting to avoid over-tightening and damaging the mounting hardware.
Attach magnetic grille
2
3
Advertisement
Table of Contents
